Battery Installation - VTech CS6719 User Manual

Getting started

Battery installation

Install the battery as shown below.
1. Plug the battery connector securely
into the socket, matching the
orientation of the engraved label.
3. Slide the battery compartment cover
towards the center of the handset
until it clicks into place.
• If the handset will not be used for a long period of time, disconnect and remove the
battery to prevent any possible leakage.
To purchase replacement batteries, visit our website at www.vtechphones.com
•
or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or
call 1 (800) 267-7377.
IMPORTANT:
Check for a dial tone by pressing
If you do not hear a dial tone:
• Make sure the installation procedures described above are properly done.
• It may be a wiring problem. If you have changed your telephone service to
digital service from a cable company or a VoIP service provider, the telephone line
may need to be rewired to allow all existing telephone jacks to work. Contact your
cable/VoIP service provider for more information.
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
. If you hear a dial tone, the installation is successful.
2. Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
4. Place the handset in the telephone
base or charger to charge.
CHARGE light
remains on
when charging.
3