Getting Started With The Configuration - Cisco ISA550 Quick Start Manual

For a DSL or cable modem, or other WAN connectivity devices,
S 3
TEP
connect an Ethernet network cable from the device to the WAN
port on the back panel. Cisco strongly recommends using
Category 5E or better cable.
(Optional) For network devices, connect an Ethernet network cable
S 4
TEP
from the network device to an available LAN port on the back panel.
Power on the connected devices.
S 5
TEP
Power on the security appliance. The lights on the front panel for
S 6
TEP
all connected ports light up to show active connections.
A sample configuration is illustrated below.
A NT01

Getting Started with the Configuration

5
You can log in to the ISA500 Series Configuration Utility and complete the
initial configuration by using the Setup Wizard; follow these steps:
Connect a computer to an available LAN port on the back panel of
S 1
TEP
the security appliance.
Your PC will become a DHCP client of the security appliance and
will receive an IP address in the 192.168.75.x range.
Start a web browser. In the Address bar, enter the default LAN IP
S 2
TEP
address of the security appliance: 192.168.75.1.
When the login page opens, enter the username and password.
S 3
TEP
The default username is cisco. The default password is cisco.
Usernames and passwords are case sensitive.
Cisco ISA500 Series Integrated Security Appliances Quick Start Guide
Public
Web Server
10 9 8 7 6
CONFIGURABLE
Network
Devices
5 4 3 2 1
L A N WA N
Internet
Access
Device
Power
12VDC
A NT02
I
O
RESET POWER
9