Before You Begin; Default Settings - Cisco ISA550 Quick Start Manual

Welcome
Thank you for choosing the Cisco ISA500 Series Integrated Security
Appliance. This guide describes how to physically install the device and
how to launch the ISA500 Series Configuration Utility to configure it.

Before You Begin

1
Before you begin the installation, make sure that you have the following:
• An active Internet account.
• Mounting hardware and related tools. The mounting kit included with
the device contains four rubber feet for desktop placement, two
rack-mount brackets, two silicon rubber spacers, eight M3 screws, four
M5 screws, and four washers for rack mounting. Instructions are
provided for wall mounting, but the wall mounting hardware is
user-supplied.
• RJ-45 Ethernet cables (Category 5E or higher) for connecting
computers, WAN and LAN interfaces, or other devices.
• A computer with Microsoft Internet Explorer 8 or 9, or Mozilla Firefox
3.6.x, 5, or 6 for using the web-based device Configuration Utility.

Default Settings

Parameter
Username
Password
LAN IP
DHCP Range
To restore the factory defaults, choose one of the following actions:
• Press and hold the RESET button on the back panel of the unit for more
than 3 seconds while the unit is powered on and the POWER/SYS light
is solid green.
• Or launch the Configuration Utility and login. Click Device Management
> Reboot/Reset in the left hand navigation pane. In the Reset Device
area, click Reset to Factory Defaults.
2 Cisco ISA500 Series Integrated Security Appliances Quick Start Guide
Default Value
cisco
cisco
192.168.75.1
192.168.75.100 to 200