Cisco EPC3925 User Manual page 41

Section
Basic Settings
4021192 Rev B
Field Description
Wireless Network
Enable or Disable the wireless network
Wireless Configuration
The default is WPS. See Wi-Fi Protected Setup (WPS) (on page 38) for more
information about using WPS.
Select Manual to manually set up your network using this option.
Network Mode
Choose one of these options for the network mode:
G only, B/G Mixed, B/G/N Mixed (factory default)
Important: When TKIP authentication only is selected, B/G/N Mixed network
mode is not available.
Radio Band
Select Enabled 2.4GHz (factory default) or Enabled 5GHz
Note: The 5GHz radio band may not be supported on some models.
Channel Width
Choose Standard - 20 MHz Channel or Wide 40 MHz Channel
Standard Channel
Select one of the channels from the drop-down list to correspond with your
network settings. All devices in your wireless network must broadcast on the
same channel in order to communicate. You can select Auto (factory default) for
automatic channel selection.
Configure Wireless Settings
41