Advertisement
ColorPod 250™
Halogen Lamp Warning:
with halogen lamps which are highly susceptible
to damage if improperly handled. Never touch the
lamps with your bare fingers as the oil from your
hands will shorten lamp life. Also, never move the
fixture until the lamps have had ample time to cool.
Remember, lamps are not covered under warranty
conditions.
Caution:
Always replace with the exact same type lamp, unless oth-
erwise specified by an authorized American DJ
with anything other than the specified part can damage your unit and
will void your manufactures warranty.
Warning:
If after you have replaced the lamp or reset the breaker
and you continue to blow either one, STOP using the unit. Contact
customer support for further instructions, you may have to return the
unit for servicing. Continuing to use the unit may cause serious dam-
age.
Lamp Replacement:
Caution! Never open the unit when in use.
Always disconnect the main power and allow the fixture ample time
to cool before attempting to replace the lamp. Lamp replacement has
been made simple by incorporating a split dome that is retained by
thumb screws. Again, please remember to always replace with the
exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
lamps. Never touch the new lamp with your bare fingers.
2. Unscrew the two thumb screws located on the bottom front of
the unit.
3. Once the thumb screws have been removed, pull the lamp
assembly cover plate up to expose the lamp.
4. Remove and replace the lamp with an exact match.
5. Reassemble in reverse order.
American DJ Supply
- www.americandj.com - ColorPod 250™ Instruction Manual Page 5
©
®
Lamp Replacement
This fixture is fitted
technician. Replace
®
ColorPod 250™
This unit is equipped with a built-in safety breaker. This breaker is
designed to close the power circuit in the event of an internal short
or power surge. This will reduce the risk of electrical shock or fire and
protect the circuitry. To reset the breaker, push the breaker button in
until you hear it "pop" back in to place. If the breaker continues to
pop, stop using the unit and contact our customer support team, the
unit may need to be returned for service.
ColorPod 250™
Trouble Shooting: Listed below are a few common problems that you
may encounter, with solutions.
No light output from the unit;
1. Be sure you have connected your unit into a wall outlet with a
matching power supply.
2. Be sure the external breaker has not popped. The breaker is locat-
ed on the rear panel.
3. Remove the lamp cover and be sure the lamp is seated in the
socket properly. Occasionally lamps become loose during ship-
ping, be sure the lamp is push in to the socket completely.
Unit does not respond to sound;
1. Be sure the unit's mode switch is in the "I" position, this is the only
mode that allows the unit to operate in sound active mode.
2. Low frequencies (bass) should cause the unit to react to sound.
Tapping on the microphone, quiet or high pitched sounds may not
activate the unit.
American DJ Supply
- www.americandj.com - ColorPod 250™ Instruction Manual Page 6
©
®
Breaker Reset
Trouble Shooting
Advertisement
