Advertisement
Simple Scan™
Sound Active Operation:
the beat of the music without any type of controller.
1. Mount your units in a safe and secure manner.
2. Connect the "slave" units to the "master" unit as detailed in the
illustration below.
3. Follow the dip switch settings on the previous page for your
desire light show. The dip switches are located next to the lens.
4. If you wish to use the optional remote control, connect it now. The
remote control will allow you to activate a blackout mode.
5. Connect the unit to main power.
6. The unit will now react to the low frequencies of music via the
internal microphone.
Master
Slave 1
Linking System:
Your Simple Scan™ system comes with built-in
programs for a four unit system. Follow the step above for proper
linking and set-up procedures. If the system is not set up completely,
blank spots will appear in the programs.
American DJ
- www.americandj.com - Simple Scan™ Instruction Manual Page 7
©
®
Operation
This function allows a system to run to
Optional MINI/C Remote Control
Slave 2
Simple Scan™
Caution:
unless otherwise specified by an authorized American DJ
technician. Replacing with anything other than the specified part can
damage your unit and will void your manufactures warranty.
Warning:
another, STOP using the unit. Contact customer support for further
instructions, you may have to return the unit for servicing. Continuing
to use the unit may cause serious damage.
Lamp Replacement:
Slave 3
use. Always disconnect the main power and allow the fixture ample
time to cool before attempting to replace the lamps. Again, please
remember to always replace with the exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
lamps. Never touch the new lamp with your bare fingers.
2. Unscrew the two thumb screws on the front of the unit.
3. Once the thumb screws have been removed, slide the lamp
assembly cover down to expose the lamp.
4. Remove and replace the lamp
5. Reassemble in reverse order.
Fuse Replacement: Disconnect from the main power supply. Insert a
standard flat head screw driver in to the fuse holder housing as illus-
trated in figure two. Turn the screwdriver in counter-clockwise direction
to remove the fuse holder. Remove the old fuse and discard it, replace
the fuse with the same type. Insert the fuse back into it's housing.
For any other service related issues, please contact American DJ
customer support.
American DJ
©
Fuse & Lamp Replacement
Halogen Lamp Warning:
with halogen lamps which are highly susceptible
to damage if improperly handled. Never touch the
lamps with your bare fingers as the oil from your
hands will shorten lamp life. Also, never move the
fixture until the lamps have had ample time to cool.
Remember, lamps are not covered under warranty
conditions.
Always replace with the exact same type lamp and fuse,
If you continue to blow either the lamp or fuse, one after
Caution! Never open the unit when it is in
- www.americandj.com - Simple Scan™ Instruction Manual Page 8
®
This fixture is fitted
service
®
®
Advertisement
