American DJ Concept 2 User Instruction page 9

Concept 2™
Warning:
If you continue to blow lamps or fuses, STOP using the
unit. Contact customer support for further instructions, you may have
to return the unit for servicing. Continuing to use the unit may cause
serious damage.
Lamp Replacement:
Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power
and allow the unit ample time to cool before attempting to replace
the lamp. Directions are located on the bottom of the body below the
power switch.
1. Be sure to follow the proper handling procedures that deal with
discharge lamps.
2. Remove the two phillips screws located in the middle on the
bottom of the unit.
3. After removing the screws, slide the lamp socket assebly out to
expose the lamp.
4. Carefully remove the old lamp.
NEVER TOUCH A DISCHARGE LAMP WITH YOUR BARE
HANDS. NEVER DISCARD A DISCHARGE LAMP IN THE
TRASH. FOR PROPER DISPOSAL INSTRUCTIONS, PLEASE
REFER TO THE INSTRUCTIONS INCLUDED WITH YOUR NEW
DISCHARGE LAMP.
5. Replace the lamp with an exact match and reassemble in reverse
order.
Concept 2™
Fuse Replacement: Caution! Always disconnect the main power
before attempting to replace the fuse. Remember always replace with
the same type lamp and fuse.
1. With a flat screwdriver wedge the fuse holder out of the its
housing
2. Remove the old fuse from the holder and replace with the
exact same type fuse.
3. Replace the fuse holder in to the fuse holder housing.
4. Reconnect main power.
American DJ Supply - www.americandj.com - Concept 2™ Instruction Manual Page 17
© ®
Lamp Replacement
Fuse Replacement
Concept 2™
This unit comes with two 14mm interchangable gobos. Chang-
ing the gobos is a easy procedure. Follow the instructions
below.
Caution! Never open the unit when in use. Always disconnect
the main power before attempting to change the gobos.
1. Unscrew the four allen screws on the body of the unit, and
the two phillips screws on bottom of the unit. Remove the
shell of the body.
2. When you remove the shell you will be able to access the
gobo wheel. Turn the wheel with your hand until you come
across the two changable gobos. Look at how the gobos are
set in the wheel. They are very easy to remove.
3. Using your thumb, push the gobo out, towards the mirror.
When doing this you do not need a lot of pressure. The same
time that you are pushing the gobo out, use your finger and
slide the gobo up and out.
If you notice how the gobo is set in the wheel it is a very
easy procedure.
4. Change the gobo, and reassemble the unit.
Concept 2™
Due to fog residue, smoke, and dust cleaning the internal and
external optical lenses must be carried out periodically to opti-
mize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the
outside casing.
2. Use a brush to wipe down the fan grill.
3. Clean the external optics with glass cleaner and a soft cloth
every 20 days.
4. Clean the internal optics with glass cleaner and a soft cloth
every 30-60 days.
5. Always be sure to dry all parts completely before plugging
American DJ Supply - www.americandj.com - Concept 2™ Instruction Manual Page 18
© ®
Changing Gobos
Cleaning