Hitachi VM-H71A Instruction Manual page 51

Advanced Techniques
It is necessary to program the edit remote control code to match the VCR
before starting editing.
1. Turn the VCR on.
2. Aim the remote control at the infrared receiver on the VCR and press
the VCR SET button on the remote control and hold it, then press the
button corresponding to the VCR's maker code. For example, if you ave a
RCA VCR, press the VCR SET button and hold it, then press the
DISPLAY button. To check whether the remote control code matches that
of your VCR or not, point the remote control at the infrared receiver on the
VCR and press the VCR SET button and hold it. If the remote control code
has been set, the VCR channel is counted up automatically.
Note: Your VCR should have an infrared remote control.
Note: If the channel on the VCR does not change with the above operation,
you need to switch the remote control code of your VCR. Refer to the VCR's
instruction manual. If the channel still does not change after you have
changed the VCR's remote control code, the edit remote control cannot
operate your VCR.
VCR Brands
Hitachi
Sony
Panasonic
Toshiba
Mitsubishi
Sanyo
Sharp
NEC
JVC
Akai
Gold Star
PHILIPS
RCA
Zenith
Magnavox
Note: The remote control code is held in memory until it is changed or the
batteries are replaced.
Press VCR SET and This Button
REVERSE
PROGRAM
FORWARD
IN
COPY START
OUT
A/V DUB
DISPLAY
COUNTER RESET
TITLE ON/OFF
51