Lens Cap; Using The Microphone Cap; Attaching The Terminal Cover - Hitachi VM-H71A Instruction Manual

Getting Started
Insert a cassette into the camera/recorder and start recording or playback;
10 seconds later, the remaining tape will be displayed. When the cassette
is ejected, the display will disappear. "
seconds after the tape starts to run.
Note: The tape remaining display appears 10 seconds after the tape starts to
run.
Note: When the remaining tape time becomes less than about three minutes,
TAPE END flashes in the viewfinder.

Lens Cap

Attach the lens cap to protect the lens when carrying or storing the
camera/recorder. During shooting attach the lens cap as shown in the
figure to prevent it from being lost.

Using the Microphone Cap

Be sure to attach the microphone cap if you rinse the camera/recorder
with water after using it. If water pressure is applied to the microphone
directly, it could cause damage to the microphone.
Position the microphone cap as shown in the figure and put it on the
microphone securely until a click is heard.

Attaching the Terminal Cover

The terminal cover protects the terminal at the bottom of the
camera/recorder from damage, dirt, dust, etc.
Attach the terminal cover if you are not using the external power cord.
" is displayed for 10
30