Getting Started; Charging The Battery; Using The Ac Adapter/Charger - Hitachi VM-H71A Instruction Manual

Getting Started

Getting Started
This section guides you through the initial preparation of the
camera/recorder. None of these processes are complex. Set aside some
time, relax, and familiarize yourself with this quality instrument.
Enjoy getting to know all about your Hitachi 8mm camera/recorder. The
more comfortable and familiar you are with the machine and its features,
the more you can make it do for you. Let's get started!
It is crucial that you read and understand all the safety instructions before
you begin. If you haven't read the safety instructions yet, please take the
time to do so now.

Charging the Battery

The first step is to set the battery to charge. Once fully charged the battery
will give an operating time of approximately 70 minutes, but this is reduced
to a half to one-third depending on how often you use zoom and stop/start
functions.
Charge the battery at a temperature range of 50°F(10°C) - 86°F(30°C) to
prevent damage to the battery.

Using the AC Adapter/Charger

To Charge the Battery Attached to the AC Adapter/Charger
1. Plug the AC adapter/charger power cord into an AC outlet. Make sure
that the wide blade fits into the wide slot. If it doesn't fit try reversing it. If
you still cannot make fit the blades fully into the outlet either contact an
electrician to replace your obsolete outlet, or use a polarized cord or outlet
accessory.
2. Push the battery till it is flush with the AC adapter/charger sliding it in
the direction of the arrow as shown in the figure.
3. The CHARGE light turns on as shown in the table to the right as
charging progresses. The CHARGE light turns off when the battery is fully
charged.
To Charge the Battery Loaded in the Camera/Recorder
You can charge the battery while it is loaded in the camera/recorder after
18