Toyostove Laser 30 Installation And Operation Instructions Manual page 8

BEFORE IGNITION
1. Open the Valve(s)
Open the valve(s) of the external fuel tank.
2. Start the Fuelflow
lf using heater for the first time, or after heater has been out of fuel, press
the red reset button once for a period of one second in order to send fuel
t o t he f u el s ump .
Note:
Make sure there is no fuel leakage from the fuel line or joints.
Also make sure fuel tank is not too high. See installation instructions.
3.
Plug in the Heater
Plug heater into a 12OY AC electrical outlet. On digital indicator pre-set
"Two Dashes" will be showing.
Note: Do not connect to an outlet shared with other appliances.
4. Set Clock
lmportant: Clock on the heater must always be set to current time.
P re ss ' HOUR' and "M lN " bu tto n to co rr ect ti me .
No t e:
' HOUR'
o r " MlN" b utt on wil l ch an ge th e ti me every one (1) u nit.
Holding the button continuously will cause the time to change rapidly.
Note:
In the event of a power failure (more than approx. 20 min.) all clock and timer setting are can-
cel l ed.
lst T!MER 2nd'š :MER POWER SAVER UP•Œ HOUR DOWNIMiN
lstT;MER
O PowER sAVER
O P E R A T 1 0 N
M A N U A L O P E R A T 1 0 N
Operation of the heater is under the direct contro:of the user.Heat output wi:|•Œ however•Œ be automatica•a
y
adiuSted in accordance with the roo"ú n tennperature registered by the ternperature sensor.
Reset button
: " ú
• ç
" ú