Toyostove Laser 30 Installation And Operation Instructions Manual page 22

INSTALLATION OF HEATER AND FLUE PIPE
IMPORTANT: Check and comply with all state and local codes that may apply to vented heaters before
b e g i n n i n g i n s t a l l a t i o n .
NOTE: This heater is designed to be used at altitudes up to 3,000 FT. above sea level.
For use at altitudes higher than 3,000 FT. and up to 6,000 FT., adjustments to the heater must be
m a de. C ons ult w ith yo ur de ale r.
1. Select heater location. Allow clearances as indicated below between heater and all other materials.
( S e e F i g . 1 )
F i g . 1
Make sure that the outside area to where the standard flue pipe will reach is clear of any objects.
( S e e F i g . 2 & 3 )
CA UT I ON ! T he s tan da r d f lu e p ipe in sta ll at io n, a s show n in Fig. 2, is fo r w all th ickn ess from 4 in. t o 9 in .
ONLY.
NO T E : F or* al l t- h ic kn ess mor e th a n 9 i n ., r efe r to pag e 18 for avai tabl e flu e p ipe e xte nsion s.
NOT E : T he fl ue pip e ca n be in sta lle d th ro ug h a ny st and ard bui ldin g ma terial s.
Not less than 2 ft
Not iess
than 2 ft.
Not less
than l ft
* B e s u r e t h i s
c l e a r a n c e w i l l
b e m a i n t a i n € d
after snowfalls,
etc.
. . .
i
. : , , . " - . : r . r ' .
<S t an da rd Fl u e P i pe In sta lla tion >
More than 2 ft.
More than l•¡ . |_ 1"Ø
•u MOre than l‹M .
Flue pipe
Fig.3
22