Troy-Bilt Mustang Series RZT Operator's Manual page 11

Hide thumbs Also See for Mustang Series RZT:
Table of Contents

Advertisement

Available languages

Available languages

Lower Deck Discharge Chute Deflector
WARNING!
Never operate the mower deck
without the chute deflector installed and in the
down position.
The discharge chute deflector must be installed before operating
the mower.
1.
Remove the keys that are attached with a zip tie to the
chute bracket.
2.
Remove the flange lock nuts from the deck. Do not remove
the push nuts or carriage bolts, leaving them in place will
aid in installing the chute. See Figure 3-5.
50" Deck
Shown
Flange Lock Nuts
Push Nuts
Figure 3-5
3.
Install the discharge chute deflector using the carriage
bolts, push nuts and flange lock nuts as shown in Figure
3-6 and securely tighten the hardware.
50" Deck
Shown
Discharge
Chute
Deflector
Push Nuts
Figure 3-6
Adjusting the Seat
To adjust the position of the seat, rotate the seat forward and
locate the clamp knob on the front left of the seat pan. Refer to
Figure 3-2.
Rotate the clamp knob to the left and remove it, slide the seat
forward or backward and re-insert the clamp knob into one of the
four available positions on the seat pan and into the seat, then
tighten securely. Make sure the seat is locked into position before
operating the tractor. See Figure 3-7.
Carriage Bolts
Flange Lock Nuts
Carriage Bolts
Seat
Adjustment
Positions
Figure 3-7
S
2 — A
ection
Clamp
Knob
& S
-U
11
SSembly
et
p

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents