Advertisement
12. 60"(FHD), 50"(FHD) POWER PCB
Ass'y Voltage Adjustment
(Va, Vs voltage Adjustment)
12-1. Model name:
12-2. Adjustment Method
(1) 60" FHD Va Adjustment (refer fig. 3)
1) After receiving 100% Full White Pattern, HEAT RUN.
2) Connect + terminal of D. M..M. to Va pin of P11, connect
-terminal to GND pin of P11.
3) After turning VR901,voltage of D.M.M adjustment as
same as Va voltage which on label of panel right/top
(deviation; ±0.5V)
(2) 60" FHD Vs Adjustment (refer fig. 3)
1) Connect + terminal of D. M..M. to Vs pin of P11, connect
-terminal to GND pin of P11.
2) After turning VR951, voltage of D.M.M adjustment as
same as Vs voltage which on label of panel right/top(
deviation ; ±0.5V)
(Fig. 3) 60inch FHD Power PCB Assy Voltage Adjustment
13. 32"(XGA) POWER PCB Ass'y
Voltage Adjustment
(Va, Vs voltage Adjustment)
13-1. Model name:
13-2. Adjustment Method
(1) 32" Va Adjustment (refer fig. 4)
1) After receiving 100% Full White Pattern, HEAT RUN.
2) Connect + terminal of D. M.M. to Va pin of P811,
connect -terminal to GND pin of P811.
3) After turning VR901,voltage of D.M.M adjustment as
same as Va voltage which on label of panel right/top
(deviation; ±0.5V)
(2) 32" Vs Adjustment (refer fig. 4)
1) Connect + terminal of D. M..M. to Vs pin of P811,
connect -terminal to GND pin of P811.
2) After turning VR951, voltage of D.M.M adjustment as
same as Vs voltage which on label of panel right/top(
deviation ; ±0.5V)
Copyright©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
50PG7000, 60PG7000, 50PG4000
32PG6000, 32PG6010
(Fig. 4) 32inch Power PCB Assy Voltage Adjustment
- Before adjusting White-balance , the AV ADC should be done.
- If ADC status were "NG", Need to ADC adjustment.
14. Adjustment of White Balance
Caution: Press the POWER ON KEY on R/C before W/B
adjustment.
14-1. Test Equipment
- Color Analyzer (CS-1000, CA-100+(CH.10), CA-210(CH.10))
[ Please adjust CA-100+ / CA-210 by CS-1000 before
measuring
--> You should use Channel 10 which is Matrix
compensated (White, Red, Green, Blue revised) by CS-
1000 and adjust in accordance with White balance
adjustment coordinate.
O
Color temperature standards according to CSM and Module
O
Change target luminance and range of the Auto adjustment
W/B equipment.
- 10 -
LGE Internal Use Only
Hide quick links:
Advertisement
