Long Speech Alarm; Col Call Arriving Alarm; Volume Control Of Arriving And; Receiving With Speaker - Panasonic Easa-Phone VA-208 Installation Manual

Wolume control of received voice l
COL call arriving alarm %This has to be Fogrammed.
Changing
Volume
Selector
@. located on the back of
the handset enables the
sound level to increase by
approximately 6 d6.
Set the volume selector to
"H" side, if it is hard to
hear the party' s voice.
In same area, only a slight
volume
increase will
noticed.
-be
l
Long speech alarm % This has to be programmed.
Alarm tone (lasting
for
approximately 0.5 second
)
can be produced every three
minutes from the beginning
of
an outgoing call.
l
Volume control of arriving and monitor tones
l
Receiving with speaker
The party' s voice can be
heard through the speaker.
Press SPKR Button ;ii
while you are on the line.
The party' s voice is still
heard through the speaker,
even if you hang up the
handset.
For returning again to the
handset conversation mode,
just lift off the handset.
If there is a delay in reply-
ing to the arriving COL
call, an alarm can be sound-
ed at all telephones.
The set time is 20 seconds
or 30 seconds after the
arrival of the COL call.
However, no alarm is sound-
NOTE :
About programming, see the programming table in the Installation Manual.
23
OFlashing
FLASH Button a basi-
cally has a function equiv-
alent to hanging up and lift
off again.
ed at the COL SC
grammed.
pro-
E
*Interruption to COL conversation %This has to be
programmed.
The arriving ringing tone
can be adjusted by means of
Tone
Ringer Volume
Control a.
Also, the s;jeaker volume
can be adjusted by Speaker
Volume Control :@
.
This feature allows the third
party to talk on the line by
interrupting the COL con-
versation.
For the interrupting opera-
tion, press Line Selector
Button of the CO line to be
interrupted.
@Outward dialing restriction %This has to be programm-
ed.
Areas, such as intra-city
areas, out-of-city area, etc.,
to which outward dialings
are allowed can be limited
for each telephone.
In addition, even for the
telephones assigned as class
2 or class 3, a restriction
can be set in order that
only the origination by
common SSD
(System
Speed Dialing) is allowed.
NOTE
:
About programming, see the programming table in the Installation Manual.
24