Transmatic Lawn Tractors 600 And 700 Series - MTD Garden Tractors User Manual

For Parts Call 606-678-9623 or 606-561-4983
10. Remove and replace the V-belt. See Figure 4-
24.
11. Upon reassembly of idler pulley, be certain the
hub side of idler goes against the idler bracket.
See Figure 4-25.
12. When sliding the idler pulley on the idler
bracket, be certain the belt is between the pul-
ley and guide pin. See Figure 4-26.
13. Reverse the above steps (paying close atten-
tion to steps 12 and 13) when reassembling
the new belts.
www.mymowerparts.com
Be certain all belts are inside belt guards and
keepers. Also, be sure to reassemble the
safety wire (yellow) at the deck chute.
4-8. TRANSMATIC LAWN TRACTORS 600 AND
700 SERIES.
4-8.1 The principle of this drive system is basically
the same as discussed earlier in the operation
of the variable speed pulley. Refer to para-
graph 4-7. This paragraph contains specific
information applicable to the 600 and 700
transmatic lawn tractors only. The layout of the
drive system is somewhat different. On the
previously used system, constant tension was
maintained on the V-belt from the variable
speed pulley to the transaxle pulley through
4-15
NOTE
4