Change Protection Code - Sagem ITD 62 User Manual

ITD61_UK.qxd 10/11/04
6. USER SETTINGS
6-6 CHANGING PROTECTION CODE
Enter your new code.
The first segment blinks until its value is entered, then
the second segment blinks, etc.
As soon as the value has been entered, the segment is
replaced with a star.
Use cursor on the remote control unit to come
back to a value that has been entered and
modify it until the whole is confirmed by
In this case, the value becomes a blinking segment
again, indicating that entry is possible.
Enter the same new code to confirm it.
If you have not entered the right code, you will see an
error message.
Indication of correct acknowledgement.
Note: use value "0000" if you do not want to enter any
protection code.
9:25 Page 22
.
15
CHANGE INSTALLATION CODE
NEW CODE
- - - -
CONFIRMATION
CHANGE INSTALLATION CODE
NEW CODE
CONFIRMATION
* * * *
CHANGE INSTALLATION CODE
NEW CODE
CONFIRMATION
* * * *
BAD CODE CONFIRMED
START AGAIN
CHANGE INSTALLATION CODE
NEW CODE
CONFIRMATION
* * * *
CORRECT
CONFIRMATION