Dish Network Hopper User Manual page 85

4
To start learning commands for this mode:
• If you've found a code for that
device, first program the code.
Now press and release RECALL,
then press and hold the RECORD
button for about three seconds.
• If you have not programmed a
code for that device, press and
hold RECORD for three seconds.
5
Point the front of the original device remote
to face the small square (IR window) on the
front, left-hand side of the DISH remote
control, as shown on page 76.
6
On the DISH remote control, press the but-
ton you want to teach.
7
On the original device's remote control,
press and hold the button for the command
that you want learned.
• If the DISH remote learns the
command, the device mode light
blinks off and then back on.
• If the mode light blinks three times
or remains lit, the DISH remote did
not learn the command.
8
After a button has learned a command suc-
cessfully, repeat step 6 and step 7 until all
commands you want have been learned.
9
To end the learning sequence:
• Press one of the mode buttons on
the DISH remote. This saves all
the commands for that mode, and
exits learning to return to normal
remote control operation.
• To cancel learning, do not press
any buttons on either remote
control for at least 30 seconds. The
DISH remote control times out of
learning and returns to its normal
operation.
Note that no learned commands
are saved if the DISH remote
control times out before completion
of learning.
Remote Controls
Controlling Other Components
To find and program the device code, use the
instructions for Setting Up Using Device Code
Tables on page 72 or Setting Up Using Device
Codes Scan on page 73.
The device mode button that you selected
remains lit while learning.
You may need to try pressing the button on the
original device's remote several times for the
DISH remote to learn the command.
The learning sequence also ends if the remote:
• Runs out of memory for learned
commands, whereupon it saves
the commands you have learned
for equipment in this mode, exits
learning and returns to its normal
remote control operation. Then the
DISH remote cannot learn any
additional commands.
• Batteries are too low for learning,
when all the mode buttons blink
quickly eight times. Learning ends
with no learned commands
saved, and the DISH remote
control returns to its normal
operation.
Change the remote's batteries.
77