Power On / Off - Panasonic TH-50PB2W Operating Instructions Manual

Power On / Off

Connecting the AC cord plug to the Plasma Display.
Connecting the plug to the Wall Outlet
Notes:
• Main plug types vary between countries. The power
plug shown at right may, therefore, not be the type
fi tted to your set.
• When disconnecting the AC cord, be absolutely
sure to disconnect the AC cord plug at the socket
outlet fi rst.
Press the Power switch on the Plasma Display to
turn the set on: Power-On.
Power Indicator: Green
[Starting up the network]
It takes some time for the network to start up just
after the power is turned on.
During that time, "Network Setup" in the "Setup" menu
is grayed out and cannot be set.
Press the
Power Indicator: Red (standby)
Press the
Power Indicator: Green
Turn the power to the Plasma Display off by pressing the
unit, when the Plasma Display is on or in standby mode.
Note:
During operation of the power management function, the power indicator turns
orange in the power off state.
14
button on the remote control to turn the Plasma Display off.
button on the remote control to turn the Plasma Display on.
+
INPUT MENU -/ VOL / ENTER/
Power Indicator
Remote Control Sensor
switch on the