When installing:
• Make sure that the DC-in connector and the fan connector are attached to the system board firmly.
• Before you attach the fan assembly to the computer, apply thermal grease, at an amount of 0.2 grams,
on the part marked
a
cause a thermal problem due to imperfect contact with a component. You need to peel the thin film
off from the rubber
b
1130 mSATA solid state drive
For access, remove these FRUs in order:
•
"1010 Battery pack" on page 62
•
"1040 Keyboard" on page 67
•
"1050 Palm rest or palm rest with a fingerprint reader" on page 69
Attention:
• Do not drop the hard disk drive or apply any physical shock to it. The hard disk drive is sensitive to
physical shock. Improper handling can cause damage and permanent loss of data.
• Before removing the drive, have the user make a backup copy of all the information on it if possible.
• Never remove the drive while the system is operating or is in suspend mode.
as in the following figure. Either too much or too less application of grease can
.
.
Chapter 8
Removing and replacing a FRU
87