Target Pinpointing Methods - Garrett ACE 350 Owner's Manual

• Swing your searchcoil parallel to plow lines and the
water's edge. This will minimize the negative effects caused
by uneven ground in plowed fields and varying amounts
of moisture near the water. Do not swing the searchcoil
perpendicular to plow lines and the water's edge, as this may
produce abrupt changes in ground response that can reduce
the detector's performance.
30 Garrett Metal Detectors

TARGET PINPOINTING METHODS

Standard pinpointing method using the Pinpoint button
(see page 15). In this method, position the searchcoil to the
side of the target's suspected location. Press and hold the
Pinpoint button, then sweep the searchcoil side-to-side and
front-to-back in a crosshair pattern to locate the peak signal.
You will notice the greatest number of pixels on the upper
scale and the strongest audio (loudest sound) as you pinpoint
the peak target signal. (See LCD meter illustration below.)
5-10cm
Note: The ACE 350 DD searchcoil's "hot spot" is under the
center of the coil, just ahead of its stem mount. The opening
just ahead of the stem mount can serve as your reference
point for pinpointing.
Indicates detected target
Indicates target pinpointing
center of the 8.5" x 11"
PROformance searchcoil.
31
ACE 350™