Kenwood KMM-257 Instruction Manual page 17

Basic procedure
Remove the key from the ignition switch, then disconnect the · terminal of the car battery.
1
2
Connect the wires properly. (See Wiring connection. (➜ 16))
3
Install the unit to your car. (See Installing the unit (in-dash mounting).)
Connect the · terminal of the car battery.
4
5
Reset the unit. (➜ 3)
Installating the unit (in-dash mounting)
How to remove the unit
Hook on the top side
Orientate the trim plate as
illustrated before fitting.
INSTALLATION / CONNECTION
Bend the appropriate tabs
to hold the mounting sleeve
firmly in place.
Do the required
wiring. (➜ 16)
Dashboard of
your car
15
ENGLISH |