Foxconn P9657MA series Manual page 36

vBoot Up Floppy Seek
This option controls whether the BIOS checks for a floppy drive while booting
up. If it cannot detect one (either due to improper configuration or physical
unavailability), it will appear an error message. The available setting values
are: Disabled and Enabled.
vBoot Up NumLock Status
This item defines if the keyboard Num Lock key is active when your system is
started. The available setting values are: On and Off.
vGate A20 Option
This option is used to set up the A20 signal control necessary for access to
the 1MB memory.
vSecurity Option
W hen it is set to "Setup", a password is required to enter the CMOS Setup
screen; W hen it is set to"System", a password is required not only to enter
CMOS Setup, but also to startup your PC.
vAPIC Mode
This option is used to enable or disable APIC function.
vMPS Version Control For OS
This option is used to set up the version of MPS Table used in OS.
vDelay For HDD(Seccs)
This option is used to set delay boot time of HDD controller.
vFull Screen Logo Show
This item allows you to enable or disable the Full Screen Logo Show.
vSmall Logo (EPA) Show
This item allows you to enable or disable the EPA logo.
Chapter 3 BIOS Description
29