Table of Contents
Advertisement
Where to Install Your
Micro Component System
GB
To take full advantage of your new micro component system,
follow these installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
For ventilation purposes,maintain an open space of approximately 6
inches (15 cm) on the sides and rear of the system.
Make sure that you have enough room to open the compact disc com-
partment easily.
Connecting your System to the
Power Supply
The main lead must be plugged into an appropriate socket.
Before plugging your system into a main socket, you must check the
voltage.
1
Plug the main lead into an appropriate socket.
2
Press the (
) button to switch your micro component system on.
6
Inserting Remote Control Batteries
Insert or replace remote control batteries when you:
Purchase the micro component system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and never
mix alkaline and manganese batteries.
1
Place your thumb on the position marked
on the battery
compartment cover (rear of the remote control) and pull the cover in
the direction of the arrow.
2
Insert two AAA, LR03 or equivalent batteries, taking care to respect
the polarities:
+ on the battery against + in the battery compartment
– on the battery against – in the battery compartment
3
Replace the cover by sliding it back until it clicks into position.
Connecting to an External Source
The auxiliary input can be used to take advantage of the sound quality
of your micro component system when listening to other sources.
Examples:
A television
A DVD player
A VCR
To connect to the external source, the source must have an audio
output.
1
Set the system to standby mode and disconnect it and the external
source from the main socket.
2
Connect the audio cable to the rear of the micro component system.
For optimum sound quality, do not invert the right and left
channels.
3
Plug the system back into the main socket and press (
) to
switch it on.
4
Select the AUX source by pressing FUNCTION.
Result: AUX is displayed.
5
Switch the external source on.
Example: You can watch a film on your DVD player and take advan-
tage of stereo sound this unit provides.
Audio Cable
If the external analog compo-
nent has only one Audio Out,
connect either left or right.
iPod Connection
You can listen to the audio from an iPod through the main unit.
1
Set the system to standby mode and disconnect it and the external
source from the main socket.
2
Choose the appropriate iPod adapter and place into the micro com-
ponent system.Place the iPod into the adapter and connect the iPod
player to the top of the micro component system.
3
Plug the system back into the main socket and press (
) to
switch it on.
4
Select the iPod source by pressing FUNCTION.
Result: Apple is displayed.
5
Switch the iPod on.
When the unit is powered on and you connect an iPod MP3 player,
the unit will charge your iPod's battery.
iPod is registered trade mark of Apple Computer,Inc.
GB
7
Advertisement
Table of Contents
