Where To Install Your Micro-Component System; Connecting Your System To The Power Supply; Inserting Remote Control Batteries - Samsung MM-L7 Instruction Manual

Cd-r/rw playback
Hide thumbs Also See for MM-L7:
Table of Contents

Advertisement

MM-L7-NO RDS(GB)
2001.12.21

Where to Install Your Micro-Component System

To take full advantage of your new MICRO component system,
follow these installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never locate this unit in an outdoor area.
Maintain an open space of approximately 6 inches
(15 cm) on the sides and rear of the system, for
ventilation purposes.
Make sure that you have enough room to open the
compact disc compartment easily.
Place the loudspeakers at a reasonable distance on either
side of the system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers
are placed at an equal distance above the floor.

Connecting Your System to the Power Supply

The main lead must be plugged into an appropriate socket.
Before plugging your system into a main socket, you must check
the voltage.
1
Check the position of the voltage selector at the bottom of the system
(OPTIONAL).
2
Plug the main lead (marked AC Cord on the rear of the system) into
an appropriate socket.
3
Press the On/Standby button to switch your mini-compact system on.
16:16
Page 7
FUNC.
Volume
R
CD/TAPE/TUNING
Tuning Mode
Display
Repeat
Repeat A B
PTY
Band
Preset EQ
+10 (CD)
Record
PRO./Set
CD Synchro
Star/Stop
VOLTAGE
SELETOR

Inserting Remote Control Batteries

Insert or replace remote control batteries when you:
Purchase the Micro component system
Find that the remote control is no longer operating
correctly
When replacing the batteries, use a new set of batteries
and never mix alkaline and manganese batteries.
1
Place your thumb on the position marked
compartment cover (rear of the remote control) and push the
cover in the direction of the arrow.
2
Insert two AAA, LR03 or equivalent batteries, taking care to
respect the polarities:
+ on the battery against + on the remote control
– on the battery against – on the remote control
3
Replace the cover by sliding it back until it clicks into position.
GB
on the battery
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents