Replacement Instructions; Attach Purifier Lock-Clip - Samsung Refrigerator User Manual

WARRANTY INFORMATION
This water line installation is not covered by the
refrigerator or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the risk of
expensive water damage.
Note:
If the coupler does not fi t on the current tap, go
the nearest authorised service dealer and purchase the
right couplers fi ttings.
select the location where the purifi er is to
install. (Model with the purifi er)
- If you wish to reassemble the water inlet and outlet
sides of the purifi er during purifi er installation, see
the reference illustration.
- Cut the water line attached to the purifi er to the
appropriate place after measuring the distance
between the purifi er and the cold water tap.
COUPLER "A"
LINE OUTLET
90 degree
SIDE OF
PURIFIER
PURIFIER WATER
COUPLER
WATER INLET
SIDE OF PURIFIER

Replacement Instructions

1. Shut off water supply.
2. Note the Flow direction on the fi lter.
3. Insert water supply tube into the inlet side of the
fi lter until the tube stop.
FLOW DIRECTION
WATER SUPPLY
INLET SIDE
Note :
14_
setting up
4. After inserting tube, put together the clip strongly.
The Clip fi x the tube.
5. Turn on the water and check for leaks. If leaks
occur, repeat step 1,2,3,4. If leaks persist,
discontinue use and call your supporting dealer.
6. Flush fi lter for 5 minutes before use.
Remove any residual matter inside the
purifi er. (Model with the purifi er)
- Open the main water tap to check whether water
is running through the water tube on the water inlet
side of the purifi er.
- If water does not come out through the line, check
whether the tap is open.
- Leave the tap open until clean water is running
out and any residual matter that built up during
manufacturing has been removed.
TAP
CAUTION
Insert Locking Clip After Insert Locking Clip After
tube seated tube seated
Attach the purifi er lock-clip.
- Hold the purifi er
lock-clip in the
appropriate
Locking Clip Locking Clip
position (under the
sink for example)
and fi x it tightly
into place where to
screw.
Secure the purifi er in position.
- Fix the purifi er
in position, as
PERMEAT
shown in the
fi gure on the
right.
You must also ensure
that the cut is square
and not at any sort
of angle as this could
cause a leak
OUTLET SIDE
OF PURIFIER PURIFIER
WATER LINE
WATER
PURIFIER LOCK-CLIP
WATER TUBE
PURIFIER LOCK-CLIP
PURIFIER