Replacement Instructions - Samsung Refrigerator User Manual

CoUPLEr "a"
LinE oUTLET
siDE of PUrifiEr
PUrifiEr WaTEr
CoUPLEr
WaTEr inLET
siDE of PUrifiEr
Replacement Instructions
1. Shut off water supply.
2. Note the Flow direction on the filter.
3. Insert water supply tube into the inlet side of the
filter until the tube stop.
fLoW DirECTion
WaTEr sUPPLy
inLET siDE
4. After inserting tube, put together the clip strongly.
The Clip fix the tube.
5. Turn on the water and check for leaks. If leaks
occur, repeat step 1,2,3,4. If leaks persist,
discontinue use and call your supporting dealer.
6. Flush filter for 5 minutes before use.
TaP
90 degree
CaUTion
insert Locking Clip after
tube seated
Locking Clip
PErMEaT
Note : You must also ensure
that the cut is square and not
at any sort of angle as this
could cause a leak
Remove any residual matter inside
the purifier. (Model with the purifier)
- Open the main water tap to check whether water
is running through the water tube on the water
inlet side of the purifier.
- If water does not come out through the line,
check whether the tap is open.
- Leave the tap open until clean water is running
out and any residual matter that built up during
manufacturing has been removed.
oUTLET siDE of
PUrifiEr
WaTEr
Attach the purifier lock-clip.
- Hold the purifier lock-clip in the appropriate
position (under the sink for example) and fix it
tightly into place where to screw.
Secure the purifier in position.
- Fix the purifier in position, as shown in the figure
on the right.
PUrifiEr LoCK-CLiP
PUrifiEr
WaTEr LinE
Purifier lock-clip
WaTEr TUBE
PUrifiEr
setting up _13