Setting Up the Remote to Operate Your DVD
1
Turn off your DVD.
2
Press the DVD button on your TV's remote control.
3
Press the SET button on your TV's remote control.
4
Using the number buttons on your remote control, enter three digits
of the DVD code listed on page 75 of this manual for your brand of
DVD. Make sure you enter three digits of the code, even if the first
digit is a "0". (If more than one code is listed, try the first one.)
5
Press the POWER button on the remote control.
Your DVD should turn on if your remote is set up correctly.
If your DVD does not turn on after set-up, repeat steps 2, 3 and 4,
but try one of the other codes listed for your brand of DVD. If no
other codes are listed, try each code, 000 through 141.
English - 72