Samsung PDP-TELEVISION Owner's Instructions Manual page 7

1 POWER IN
Connect the supplied power cord.
2 Connecting external Audio Devices
Connect RCA audio signals from the TV to an
external source, such as Audio equipment.
3 SERVICE
− Connector for service.
− Connect the serial jack between the electro-
motion wall mount bracket and your TV
when you want to adjust the TV viewing
angle using your remote control.
4 VIDEO / AUDIO L/R
Video and audio inputs for external devices,
such as a camcorder or VCR.
5 COMPONENT IN 1, COMPONENT IN 2
Audio (AUDIO L/R) and video (Y/P
for Component.
6 DIGITAL AUDIO OUT (OPTICAL)
Connect to a Digital Audio Component. According
to the received audio signal, optical output is
selectcted by Dobly or PCM signal. The level of
sound can change according to received signal
and sound level's difference can be.
7 PC IN / AUDIO
Connect to the video and audio output jack on
your PC.
8 HDMI IN 1, HDMI IN 2
− Connect to the HDMI jack of a device with
HDMI output. These inputs can also be used
as a DVI connection with separate analog
audio inputs. An optional HDMI/DVI cable
will be necessary to make this connection.
When using the optional HDMI/DVI adapter,
the DVI analog audio inputs on your TV
allow you to receive left and right audio from
your DVI device. (Not compatible with PC)
− When connecting this product via HDMI or
DVI to a Set Top Box, DVD Player or Games
Console etc, make sure that it has been
set to a compatible video output mode as
shown in the table below. Failure to observe
this may result in picture distortion, image
breakup or no picture.
− Do not attempt to connect the HDMI/DVI
connector to a PC or Laptop Graphics Card.
(This will result in a blank screen being
displayed)
DVI IN (HDMI 2) AUDIO L/R
DVI audio outputs for external devices.
The external devices that support lower
version HDMI mode may not implement sound
ouput for theTV with the latest HDMI version
(HDMI 1.3.) In this case, connect to HDMI IN2
and DVI IN (HDMI 2) " R-AUDIO-L" on the
back panel of the TV.
Part of lower version HDMI cables may cause
annoying flickers or no screen display in this
case use the cable that supports the latest
HDMI version(HDMI 1.3).
9 ANT IN
75Ω Coaxial connector for Aerial/Cable
Network.
Supported modes for HDMI and Component
HDMI/
DVI 50Hz
HDMI/
DVI 60Hz
Component
/P ) inputs
B R
English - 7
480i 480p 576i 576p 720p 1080i 1080p
X X X O
X O X X
O O O O
O O O
O O O
O O O