Check The Water Supply Line; Connect The Water Line To The Refrigerator - Samsung REFRIGERATOR Owner's Manual And Installation

INSTALLATION OF THE WATER DISPENSER LINE

Check the water supply line

Connect the water pipe with coupler and tap.
- Close the main water tap.
- Connect coupler "A" to the tap.
- Every join should be protected with sealing tape.
WARRANTY INFORMATION
This water line installation is not covered by the refrigerator
or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the risk of
expensive water damage.
Note:
If the coupler does not fit on the current tap, go the nearest
authorised service dealer and purchase the right couplers fit-
tings.

Connect the water line to the refrigerator

- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.
If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
Secure the water line
- Using clip "A", fix the water line to the wall (the back of refrigerator).
- When the water line is secure, make sure whether the water line is not excessively bent,
pinched or squashed.
Complete the installation of the water supply line.
- Power on the refrigerator and press the lever on the right of the dispenser until water runs
out through the water line and all air has been emptied.
- At this time, check for any possible leakages at the join point in the water line.
After securing the water line, move the refrigerator to the required location.
Once the refrigerator is in position, do not move it as much as possible.
The water line must be connected
to the cold water pipe.
If it is connected to the hot water pipe,
it may cause the purifier to malfunction.
COUPLER "A"
WATER LINE
27
CAUTION
TAP
CONNECTION NUT
COMPRESSOR COVER OF
REFRIGERATOR
CLIP A
WATER LINE