Stocking The Beverage Center; Lighting The Beverage Center; Beverage Center Care; Base Grille - Jenn-Air BEVERAGE CENTER Use & Care Manual

Remove and Replace the Bottom Rack
1. Lift the rack (front and back) up and pull straight out to
remove.
2. Replace the rack by pushing it straight back and over the
stop. Continue pushing the rack evenly until it is in place.

Stocking the Beverage Center

NOTES:
For optimum wine storage, place white wines on the upper
rack of the beverage center and place red wines on the lower
rack of the beverage center.
The wine racks can be stocked with the bottles facing either
direction, however, to optimize storage adjacent bottles
should be facing in opposite directions.
To stock the beverage center:
1. Starting on the left-hand side of the bottom rack, place the
first bottle with the neck of the bottle facing the front of the
beverage center.
2. Place the next bottle on the rack with the neck of the bottle
facing the back of the beverage center. Alternate the direction
of the bottles, in this manner, until the display rack is full.
3. Slide the bottom rack into place and pull the next rack
forward. Stock the remaining rack as described In the
previous steps.
4. Place juices, sodas or other canned beverages on the glass
shelves.
8
To remove or adjust the upper glass shelves:
NOTE: The very bottom glass shelf is fixed in place and is not
removable.
1. Remove the shelf by lifting it up and out of the shelf brackets.
2. Remove the two shelf brackets and reposition them in the
desired location.
3. Replace the shelf by inserting it into the shelf brackets.
NOTE: Be sure the shelf is level.

Lighting the Beverage Center

The beverage center has an interior light that comes on anytime
the door is opened. You may also choose to keep the light on at
all times by pressing the left side of the switch, located next to the
temperature control, on the base grille.
NOTES:
Leaving the light on for an extended period of time will slightly
increase the temperature of the beverage center.
The light is an LED which does not need to be replaced. If the
LED does not illuminate when the door is opened, call Service
to replace the light. See Assistance or Service for contact
information.

BEVERAGE CENTER CARE

Base Grille

You must remove the base grille to access the condenser coils for
cleaning.
To remove the base grille:
1. Open the beverage center door to access the base grille.
2. Using a Phillips screwdriver, remove the two screws.
3. Push both tabs in toward the center to release the base grille
from the cabinet and remove.
A
To replace the base grille:
1. Open the beverage center door.
2. Position the base grille so that both tabs align and the base
grille snaps into place. Replace the two screws. Tighten the
screws.
B A
A. Tabs
B. Screws