Section 4. Programming; Timer Programming; Clock Set - Henny Penny HHC-990 Operator's Manual

4-1. TIMER PROGRAMMING

4-2. CLOCK SET

(Time-of-day, date, and
day of the week)
303
SECTION 4. PROGRAMMING
This section explains the following programming functions.
• Timer programming
• Clock-set
• Special programming
To enter the Program Mode:
1. Press and hold
shows in display.
2. After 5 seconds, "ENTER CODE" shows in display.
3. Press
"TO SELECT FOR PROGRAMMING," followed by
"USE UP AND DOWN TO CHANGE SELECTED
TIMERS," scrolls through the display.
4. Press the desired timer button (1-15). (More than one can
be programmed at one time).
5. Press
6. Once timers are set, press and hold the
settings become active and normal operation is resumed.
1. Press and hold
"CLOCK SET" shows in display.
2. After 5 seconds, "ENTER CODE" shows in display.
3. Press
4. "CS-1, SET, HOUR", and the time of day (with the hour
flashing) shows in the display.
5. Press the
Model HHC-990
for 2 seconds, and "PROG TMRS"
, and "PUSH TIMER BUTTON
to change the selected timer settings.
, and new timer
for 5 seconds, and LEVEL 2, then
.
to change the hours.
4-1