Table of Contents
Advertisement
Cooling Your Room
10
E-
You must select the Cool mode if you wish to adjust the:
◆ Cooling temperature
◆ Fan speed when cooling
1
If necessary, press the
Result:
◆ The operation indicator on the indoor unit lights up.
◆ The air conditioner starts up in the mode selected
when the unit was last used.
◆ The indoor unit beeps.
The air conditioner is fitted with a protection mechanism to
CAUTION
prevent the unit from being damaged when it is started
immediately after being:
◆ Plugged in
◆ Stopped
lt will start up normally after 3 minutes.
2
If the
is not displayed at the top of the remote control, press the
on the remote control one or more times until it appears.
Result:
◆ The indoor unit beeps each time you press the
◆ The air conditioner runs in COOL mode.
Note
You can change modes at any time.
3
To adjust the temperature, press the
required temperature is displayed.
Possible temperatures are between 18°C and 30°C inclusive.
Result:
◆ Each time you press the
- The temperature is adjusted by 1°C
- The indoor unit beeps
◆ The air conditioner starts cooling, provided that the room
temperature is higher than the selected temperature.
◆ If the room temperature reaches the set temperature, the air
conditioner stops cooling, but the fan is still operating.
4
Select the fan speed by pressing the
the required setting is displayed:
Automatic (rotated :
Low
Medium
High
Turbo (maximum)
Result:
Each time you press the
5
To control the direction of the air flow, refer to page 17.
(On/Off ) button.
button one or more times until the
button:
button one or more times until
button, the indoor unit beeps.
button
button.
)
Advertisement
Table of Contents
