Connectors And Buttons; Led Indicators - Axis P5512-E User Manual

AXIS P5512-E PTZ Dome Network Camera
Hardware Overview

Connectors and Buttons

For technical specifications, see page 51.
Network Connector
RJ45 Ethernet connector. Supports Power over Ethernet (PoE).
NOTICE NOTICE NOTICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network switch
shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. For
information about regulatory requirements, see Regulatory Information, on page 2 .
SD Card Slot
An SD card (not included) can be used for local recording with removable storage. For more information, see Technical Specifications.
NOTICE
NOTICE NOTICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System
Options > Storage > SD Card and click Unmount.
Control Button
The control button is used for:
Resetting the product to factory default settings. See page 46.
•
Connecting to an AXIS Video Hosting System service. See page 40. To connect, press and hold the button for about 1
•
second until the Status LED flashes green.
Connecting to AXIS Internet Dynamic DNS Service. See page 40. To connect, press and hold the button for about 3 seconds.
•
Restart Button
Press the restart button to restart the product.

LED Indicators

LED
Status
Color
Unlit
Amber
Amber/red
Red
Green
Indication
Connection and normal operation
Steady during startup. Flashes during firmware upgrade.
Flashes amber/red if network connection is unavailable or lost.
Flashes red for firmware upgrade failure.
Shows steady green for 10 seconds for normal operation after restart.
6