Impex MWM 1600 Owner's Manual page 7

STEP 3 (See Diagram 3)
A.) Attach the Seat Support (#12) to the Leg Developer Holder (#118). Secure it with three M10
x 5/8" Allen Bolts (#102) and
B.) Attach the Leg Developer Holder (#118) to the Base Frame (#1). Secure it with a M10 x 3 ¾"
Carriage Bolt (#92),
of Seat Support (#12) with bracket to the Front Vertical Beam (#3). Attach the 4 5/8" x 3"
Bracket (#54) to the back of Front Vertical Beam (#3). Then Secure the Vertical Beam with
two M10 x 2 3/8" Carriage Bolts (#94),
NOTE: Make sure the Bench Press is in front of the stopper underneath the Seat Support.
C.) Attach the Leg Developer (#13) to the bracket on top of the Leg Developer Holder (#118).
Insert a M10 x 2 1/8" Leg Developer Axle (#88). Secure it with two M10 x 5/8" Allen Bolts
(#102) and ¾" Washers (#114). Securely tighten all the nuts and bolts previously
installed.
¾" Washers (#114).
¾" Washer (#114) and M10 Aircraft Nut (#112). Attach the other end
¾" Washers (#114), and M10 Aircraft Nuts (#112).
6
DIAGRAM 3