Advertisement
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches. NOTE: It is strongly recommended two or more people assembling this
machine to avoid possible injury.
STEP 1
(See Diagram 1)
A.) Do not tighten all Nuts and Bolts installed until instructed to do so.
B.) Attach the Middle Support Frame (#11) to the Front Support Frame (#6). Secure them
together with two M10 x 2 ½" Carriage Bolts (#56), one 4 ¾" x 2 ¾" Bracket (#21), two Ø
¾" Washers (#70), and two M10 Aircraft Nuts (#75).
C.) Attach the Leverage Rear Stabilizer (#12) to the Middle Support Frame. Secure them with
two M10 x 2 ½" Carriage Bolts (#56), one 4 ¾" x 2" Bracket (#20), two Ø ¾" Washers
(#70), and two M10 Aircraft Nuts (#75).
D.) Attach the Diagonal Support (#18) to the Front Support Frame (#6) and Middle Support
Frame (#11). Secure each end of Diagonal Support with one M10 x 5/8" Allen Bolt (#64)
and Ø ¾" Washer (#70).
E.) Insert the Lat Bar Frame Insert (#14) halfway into the opening on the Front Support
Frame (#6). Attach two Double Brackets (#19) to the top holes on the Front Support
Frame (#6). Align the holes and secure it with one M10 x 2 ½" Carriage Bolt (#56), one
M10 x 3 3/8" Carriage Bolt (#57), two Ø ¾" Washers (#70) and two M10 Aircraft Nuts
(#75).
F.) Slide the Lat Bar Frame (#7) onto the upper half of the Lat Bar Frame Insert (#14). Align
the upper holes on the Double Brackets (#19) to the holes on the Lat Bar Frame (#7).
Secure it with one M10 x 2 ½" Carriage Bolt (#56), one M10 x 3 3/8" Carriage Bolt (#57),
two Ø ¾" Washers (#70) and two M10 Aircraft Nuts (#75).
G.) Securely tighten all Nuts and Bolts previously installed.
H.) Insert a Weight Post (#13) into the hole on the Leverage Rear Stabilizer (#12). Secure it
with one M10 x 1" Allen Bolt (#62) and Ø3/4" Washer (#70). Attach an Olympic Sleeve
(#27) onto the Weight Post. Attach a Spring Clip (#31) onto the Sleeve. Repeat the same
procedure to install the other side.
I.) Attach the Foot Plate (#17) to the pivot on the Front Support Frame (#6). Secure it with
one M10 x 4 ¾" Allen Bolt (#61) and Ø ¾" Washer (#70) from each side.
8
Hide quick links:
Advertisement
