Page 1
Hardware Pack Assembly Instruction Exploded Diagram Parts List Warranty Ordering Parts Model MSS-7500 Retain This Manual for Reference 06/11/09 ® IMPEX INC. 14777 Don Julian Rd., City of Industry, CA 91746 OWNER'S Tel: (800) 999-8899 Fax (626) 961-9966 MANUAL www.impex-fitness.com info@impex-fitness.com...
ORDERING PARTS..................BEFORE YOU BEGIN Thank you for selecting the SA GEAR WEIGHT BENCH MSS-7500 by ® IMPEX INC. For your safety and benefit, read this manual carefully before using the machine. As a manufacturer, we are committed to provide you complete customer satisfaction.
OVER THE AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC. ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT. SAVE THESE INSTRUCTIONS.
Page 4
WARNING LABEL PLACEMENT The Warning Labels shown here have been placed on the Cross Brace. If the label is missing or illegible, please call customer service at 1-800-999-8899 for replacement. Apply the label in location shown...
ASSEMBLY INSTRUCTION Tools Required For Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches. NOTE: It is strongly recommended for two or more people to assemble this machine to avoid possible injury. STEP 1 (See Diagram 1) A.) Do not tighten the Nuts and Bolts until instructed to do so. B.) Connect the two Upright Beams (#1) by a Cross Brace (#2) in the mid-span.
Page 8
STEP 2 (See Diagram 2) A.) Attach the Main Seat Support (#3) to the Front Post (#4). Secure it with two M10 x 2 3/8” Carriage Bolts (#32), one 6 ¼” x 3 ¼” Bracket (#14), two Ø ¾” Washers (#36), and two M10 Aircraft Nuts (#38).
Page 9
STEP 3 (See Diagram 3) A.) Attach the Seat Bracket (#5) to the pivot on the Main Seat Support (#3). Attach the holes on the end of the two Backrest Supports (#6) to the Seat Bracket. Align the holes. Secure the two Backrest Supports, Seat Bracket together to the pivot with one M12 x 7”...
Page 10
STEP 4 (See Diagram 4) A.) Attach the Leg Developer (#9) to the open bracket on Main Seat Support (#3). Secure it with one Leg Developer Axle (#21), two M10 x ¾” Allen Bolt (#33), and two Ø ¾” Washers (#36).
PARTS LIST KEY NO. DESCRIPTION QUANTITY Upright Beam Cross Brace Main Seat Support Front Post Seat Bracket Backrest Support Crutch Backrest Adjustment Bar Leg Developer Foam Tube Backrest Board Seat Pad 5 ½” Curved Bracket 6 ¼” x 3 ¼” Bracket 5 ½”...
IMPEX. IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in connection with the use or performance of the product or other damages with respect to any economic loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation or other consequential damages or whatsoever natures.