Impex IGS-5100 Owner's Manual page 18

STEP 7 (See Diagram 7 & Cable Loop Diagram)
A.) Insert the tip of the 133" Cable (#31) through the opening on the Foot Plate (#10) to the
opening on the bottom of the Rear Vertical Beam (#6).
B.) Attach a Pulley (#38) to the opening. Attach the Foot Plate (#10) to the Frame. Align the
holes and secure the Foot Plate, Rear Vertical Frame, and the Pulley with one M10 x 2
½" Allen Bolt (#78), two Ø 1" x ½" Pulley Bushings (#50), and one M10 Aircraft Nut (#83).
Secure the Foot Plate to the Frame with one M10 x 2 3/8" Carriage Bolt (#71), Ø ¾"
Washer (#86), and M10 Aircraft Nut (#83).
C.) Draw the Cable underneath the Pulley to the opening on the Rear Vertical Frame Base
(#7). Install a Pulley with a M10 x 2 1/8" Allen Bolt (#73), two Ø 1" x ¼" Pulley Bushings
(#51) and one M10 Aircraft Nut (#83). Draw the Cable around the Pulley then upward to
the Double Floating Pulley Bracket (#35) previously installed in Step-5. Install another
Pulley with one M10 x 1 ¾" Allen Bolt (#77), two Ø ¾" Washers (#86), and one M10
Aircraft Nut (#83). Note: After finishing the entire cable assembly, come back to this step
and adjust the tension of the cables. To increase the tension, move up the Pulley on the
Double Floating Pulley Brackets. To decrease the tension, move the Pulley down.
D.) Draw the Cable around the Pulley then downward to the open bracket on the back of the
Rear Vertical Frame (#6). Install another Pulley.
E.) Draw the Cable around the Pulley and upward to the Single Floating Pulley Bracket (#23)
previously installed in Step-6. Secure the Cable to the Bracket with one M10 x 1" Allen
Bolt (#74), two Ø ¾" Washers (#86), and one M10 Aircraft Nut (#83).
F.) Connect the Long Chain (#62) to the Cable with a C-clip (#49). Depends on the exercise,
connect one of the Shiver Bar (#24), V Bar (#43), Ankle Strap (#60), Single Handle (#61),
or the Triceps Rope (#45) to the Chain with another C-clip.
17