Follett HMF1400R Operation And Service Manual page 21

11. Reconnect transport tube to louvered docking assembly.
12. Plug sensor in at the electrical box.
13. Reconnect vent tube to the shuttle housing as shown.
14. Apply a coat of petrol-gel to the auger shaft.
15. Install gearmotor, making sure that insulation is properly
seated between gearmotor and main housing as shown.
16. Firmly tighten four gearmotor bolts in place.
14. Insert a bolt into the auger shaft and fi nger tighten.
15. Using a wrench, rotate the shaft clockwise to align the
keyways in the gear housing and the shaft so as to
accept the key.
16. Insert the key into the keyway.
Horizon 1400R/N Ice Machines
Fig. 22
Fig. 23
Apply
petrol-gel
Fig. 24
21