Husqvarna Collection Kit 966610501 Operator And Parts Manual page 8

3
MOUNTING COVER ASSEMBLY
TO SUPPORT ASSEMBLY
For ease of assembly, you may wish assistance from
another person for mounting the cover assembly to
mower.
1. Position cover assembly on the ground behind the
mower.
2. Lift and rotate cover to align the frame bracket
with the hanger and slide the cover down until
secure.
Hanger
4
INSTALLING SPACER PLUG
Remove plastic end cap from the center bag
support arm. Fully insert spacer plugs into the
ends of the support tube. It may be necessary
to tap the spacer into place with a hammer or
mallet. Replace the plastic end cap back over
the spacer. The additional extension will hold the
hood more securely when latched.
Insert
spacer and
replace cap
Remove
center end
cap
8
ASSEMBLY
5
CONTAINER INSTALLATION
1. Install containers on support frame, overlapping
containers at center tube.
Note: One container should always overlap the
other container at the center tube.
2. Close cover and lock latch handle over support
tubes.
Cover
Assembly
Frame
Bracket
Latch Handle
Support
Frame