Assembly; Fitting The J-Handle; Assembling And Dismantling The Two- -Piece Shaft - Husqvarna 128DJ Operator's Manual

NOTE:
Make sure unit is assembled cor-
rectly as shown in this manual.

Fitting the J-handle

S Clip the loop handle onto the shaft.
Note that the loop handle must be fitted
between the arrows on the shaft.
S Slide the spacer into the slot in the loop
handle.
S Fit the nut, knob and screw. Do not over-
tighten.
S Attach the J- -handle to the loop handle
using the three screws as shown.
S Make a final adjustment of the handle to a
comfortable working position. Tighten the
bolt/knob.
WARNING:
To avoid serious
injury, only use grass blades/grass
cutters or trimmer heads with plastic
blades when the J-handle is fitted.
Never use saw blades!
Assembling and dismantling
the two- -piece shaft

Assembly:

S Loosen the coupling by turning the knob.
115476927 Rev. 2 5/15/12
ASSEMBLY
S Position locking/release button (A) of
attachment into guide recess (B) of
coupling.
S Push the attachment into the coupling
until the locking/release button snaps into
the primary hole (C).
C
ENGINE
S Before using the unit, tighten the knob
securely.
WARNING:
designed to be used in the primary
hole unless otherwise stated in the
applicable attachment instruction
manual. Using the wrong hole could
lead to serious injury or damage to
the unit.
Dismantling:
S Loosen the coupling by turning the knob.
S Press and hold the locking/release button
(A).
S While securely holding the engine and
upper shaft, pull the attachment straight
out of the coupling.
A
B
All attachments are
A
English--- 10