Table of Contents
Advertisement
Cooling Your Room
Remote Control
Control Panel
8
E-
You must select the Cool mode if you wish to lower the temperature
in your room.You can also set the fan speed.
If necessary, press the
Result:
The air conditioner starts up in the Cool mode.
The unit beeps twice.
The air conditioner is fitted with a protection mechanism to prevent
the unit from being damaged when it is started immediately after
being:
Plugged in
Stopped
It will begin to cool after three minutes.
If the COOL indicator is not lit up on the unit:
Press the
button on the remote control
or
Press the
button on the unit one or more times until the COOL
indicator lights up
Result:
The unit beeps each time you press the
The air conditioner starts up in Cool mode.
You can change modes at any time.
3
To adjust the temperature, press the
control one or more times until the required temperature is displayed.
To adjust the temperature, press the
or more times until the required temperature is displayed.
Possible temperatures are between 8°C and 30°C inclusive.
Result:
Each time you press the temperaure buttons.
- The temperature is adjusted by °C and
displayed on the control panel
- The unit beeps
The air conditioner starts cooling if the room temperature
is higher than the selected temperature.
4
To set the fan speed to... Then...
Press the
,
or
Press the
desired fan speed(F,F, or F3) is displayed.
: Low Speed
: Med Speed
: High Speed
To control the direction of the air flow, refer to page .
5
(On/Off) button.
or
or
or
button on the remote control as desired
button on the unit one or more times until the the
/
button.
button on the remote
button on the unit one
Advertisement
Table of Contents
