Static Router Ports Entry - D-Link DES-3350SR User Manual

Static Router Ports Entry

A static router port is a port that has a multicast router attached to it. Generally, this router would have a connection to a WAN or
to the Internet. Establishing a router port will allow multicast packets coming from the router to be propagated through the
network, as well as allowing multicast messages (IGMP) coming from the network to be propagated to the router.
A router port has the following behavior:
•
All IGMP Report packets will be forwarded to the router port.
•
IGMP queries (from the router port) will be flooded to all ports.
•
All UDP multicast packets will be forwarded to the router port. Because routers do not send IGMP reports or implement
IGMP snooping, a multicast router connected to the router port of the Layer 2 switch would not be able to receive UDP
data streams unless the UDP multicast packets were all forwarded to the router port.
Click Static Router Ports Entry under the IGMP folder on the Configuration menu:
To add a static router port configuration, click the pointer icon:
D-Link DES-3350SR Standalone Layer 3 Switch
Last Member Query
Interval
Host Timeout (1-
16711450)
Router Timeout (1-
16711450)
Leave Timer (1-
16711450)
Querier State
State
Figure 7 - 9. Current Static Router Ports Entries window
packets. A value between 2 and 255 can
be entered, with larger values being
specified for VLANs that are expected to
lose larger numbers of packets.
Specifies the maximum amount of time
between group-specific query messages,
including those sent in response to leave
group messages. The default is 1 second.
Specifies the maximum amount of time a
host can be a member of a multicast group
without the switch
membership report.
seconds.
Specifies the maximum amount of time a
route will remain in the switch's forwarding
table without receiving a membership
report. The default is 260 seconds.
Specifies the maximum amount of time
between the switch receiving a leave group
message from a host, and the switch
issuing a group membership query. If the
switch does not receive a response from
the group membership query before the
Leave Timer expires, the forwarding table
entry for the multicast address is deleted
from the switch's forwarding table. The
default is 2 seconds.
This field can be switched using the pull-
down menu between
Enabled.
This field can be switched using the pull-
down menu between
Enabled. This is used to enable or disable
IGMP Snooping for the specified VLAN.
28
receiving a host
The default is 260
Disabled and
Disabled and