Kenmore 1347 Instructions Manual page 7

®
®
/
®
1. Release clutch by turning clutch
knob toward you,
2, Draw thread from spool through
bobbin winder tension disc as
shown,,
3, Pull end of thread through hole in
bobbin as shown.
4, Place bobbin onto bobbin winder
shaft with end of thread coming
from the top of the bobbin_ Push
:i:i: =
bobbin winder latch against bob-
bin until it clicks. Holding onto
end of thread, start machine, When
bobbin is slightly filled, snip off
end of thread,
5,, Start machine, Wind thread until
bobbin winder latch releases
6. Tighten clutch knob and remove
bobbin,