Appendix; Adding And Registering Handsets/Headsets; Register A Handset To The Telephone Base - AT&T CL83101 Complete User's Manual

Appendix

Adding and registering handsets/headsets

Your telephone can support up to 12 DECT 6.0 cordless handsets (AT&T model
CL80111, sold separately) or up to ten cordless handsets and two cordless
headsets (sold separately). Visit
for a list of compatible DECT 6.0 cordless headsets. Each new handset or
headset must be registered to the telephone base before use. You must
register each handset or headset separately.
To register a cordless headset to this telephone system, please refer to the
user's manual of the cordless headset for more details. To register a cordless
handset, see below.
The handsets provided within your product box are already registered as
HAND�ET 1 and so forth. Additional handsets are assigned numbers in the
sequential order they are registered (up to HAND�ET 12).

Register a handset to the telephone base

1. Before you begin registration, make sure the handset is out of the telephone
base or charger and shows To register, see manual.
2. Put the handset you wish to register on the telephone
base cradle.
3. Both the handset and the telephone base show
Registering... �lease wait and the IN U�E light on the
telephone base turns on. Then HAND�ET X Registered
appears on both the handset and the telephone base
HAND�ET represents the handset name,
screens ( (
X represents the handset
the telephone base beep and the IN U�E light turns off.
The handset is now registered with the telephone base.
If registration fails, the system will automatically try
to register again. If registration fails after the third try,
Registration failed appears on both screens. Then the
handset shows To register, see manual and the telephone
base returns to idle mode. This
may take up to five minutes to
occur. Please start again from
Step 1 above.
NOTES:
• You cannot register a handset if
any other system handset is in use.
• If you try to register more than
12 handsets to the telephone
base, the telephone base shows
Registration slots are full and
sounds two beeps.
www.telephones.att.com/headsets
number). Both the handset and
For registration, put the handset on the telephone
base, not the handset charger.
88
To register,
see manual.
Registering...
Please wait
HANDSET X
Registered