Summary of Contents for Omega Research & Development AL-100DP
Page 1
Full-Feature Vehicle Security System for BACK COVER Factory-Equipped Remote Keyless Entry PRINTER’S NOTE: Transmitters production back cover Owner’s Guide is to be printed with color front cover; this is a place marker cover. Copyright 2007 Omega Research and Development, Inc. www.caralarm.com 3/07 MO/AL-100DP...
Page 2
The factory setting of this feature is off. your vehicle’s existing factory-installed remote keyless entry system. When armed, the AL-100DP can detect an unauthorized entry of the vehicle, and reacts 3rd Channel Activation: This feature allows you to choose how to activate the 3rd channel by sounding the horn and flashing the lights;...
Page 3
"Arming" places the AL-100DP into a state which monitors the vehicle for intrusion and the AL-100DP Arms 90 seconds after, the doors will also lock (connection of the attempts. Arming occurs when you lock the vehicle’s doors with the vehicle’s keyless entry AL-100DP to the vehicle’s doorlocking system is required).
Page 4
“Automatic Rearming” sequence will pause until the point of entry when the AL-100DP Arms 30 seconds after the last door is closed, the doors will also is closed again. Turning on the ignition will cancel this operation. Also, placing the system lock (connection of the AL-100DP to the vehicle’s doorlocking system is required).
The Optional Shock Sensor with Prewarn The Armed System When the AL-100DP is armed, the Status Light flashes continuously in a slow and steady Your AL-100DP security system easily allows the addition of an optional dual-zone shock manner. In this state, any violation of a protected entry will instantly activate, or "trigger" the sensor to increase the effectiveness of your system.
This Zone Violation code will then be seen at all times, until the ignition switch is turned on, which clears the system's memory. “Disarming” removes the AL-100DP from its state in which it monitors the vehicle for •...
Page 7
60 seconds to power doorlocks, but this will have no effect on the AL-100DP. It will not Arm automatically illuminate the way to your vehicle. During this 60 second period of illumination, if the ignition from Automatic Rearming or Last Door Arming (if the later is programmed to operate), nor switch is turned on the lights will immediately turn off.
Page 8
Disarmed state. Most other security systems require the ignition switch to be on to enter Valet Mode, but with the AL-100DP, to enter Valet The Valet Switch - Valet Mode and Override Mode the ignition can be either on or off as long as the system is Disarmed.