Agilent Technologies Agilent 35900E User Manual page 46

6
Parts Replacement
Figure 14
3 Tilt the SIMM memory board towards the front of the unit about 45° and
4 If installed, repeat the process for the second SIMM.
5 Seat the SIMM memory board in the slot so that the posts are aligned with
6 Push the board backwards until the metal tabs slip over the ends of the
46
Front of unit
Removing the SIMS memory board
slide it out. (See Figure 14)
If using only one SlMM board, it must be installed in the slot closest to the
front of the unit.
If using two SIMM boards, the front slot must be empty in order to install a
SIMM in the rear slot. Therefore, when using two SIMM boards, install the
rear SIMM first and then the front one.
the holes in the upper corners of the board and the memory chips mounted
on the SIMM board face the rear of the unit. (The board will be slightly tilted
forward.)
SIMM board and the white posts fit through the holes. The board will be
seated vertically in the connector.
Tabs
User Manual