Troubleshooting; Care And Maintenance; Stealthview Will Not Turn On; Image Is Not Focused - Bushnell StealthView 260542 Instruction Manual

Digital night vision, 5 x 42
Hide thumbs Also See for StealthView 260542:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

TROUBLESHOOTING

StealthView will not turn on

1. Check that the batteries and battery cartridge (2) are installed correctly. If the batteries and cartridge are installed correctly
and the batteries are good, then the green LED indicator light should be on.
2. Check that the power button (3) has been depressed to the ON position.

Image is not focused.

1. Adjust the focus of the objective lens (1) and eyepiece diopter (9).
2. Adjust the LCD brightness screen up or down until satisfactory.
3. Try turning the super I.R. spotlight ON (10). Typically, the super I.R spotlight needs to be on when viewing objects far away
in complete darkness and can be off when viewing objects at close distances with some ambient light.

CARE AND MAINTENANCE

Your Bushnell Digital Night Vision device was designed to provide many years of reliable service. To ensure that you get the
most enjoyment out of your Digital Night Vision device, always obey the following warning and precautions.
• Do not open the body of the device or otherwise attempt to service this device.
• Always store the device in a dry, well ventilated room.
• Keep the device away from any heating and air conditioning vents or other heating devices, direct sunlight, and moisture.
• Avoid dropping or otherwise shocking the unit. Although designed for rugged outdoor use, this device incorporates a
sophisticated digital circuitry which could be damaged in extreme cases of misuse.
• Clean the optical lens with a professional lens cleaning supplies.
• Clean the exterior of the device with a soft clean cloth.
• Avoid removing the objective lens as the CMOS chip can be damaged.
• Do not leave the device in direct sunlight or rain.
• Do not cover the vent grid (8) of the super I.R.
• The device can be powered with 6 nickel cadmium batteries or 6 alkaline batteries.
• The super I.R. is focused correctly from the factory. Do not attempt to adjust the focus of the super I.R.
• Remove the batteries if the device will not be used for longer than 2 months.
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents