Led Information - Cradlepoint MBR1400 Series Setup Manual

LED Information

11
SIGNAL STRENGTH BUTTON Blue LED bars indicate the active modem's signal strength. Press button to
turn on/off. 4 Solid Bars = strongest signal. 1 Blinking Bar = weakest signal.
POWER The MBR1400 must be powered using an approved 12V DC power source.
Green = Powered On. No Light = Not receiving power. Check that the unit is connected to an outlet.
Amber = Attention. Check router status page.
NETWORK LAN CONNECTION Indicates a connected device on the 1-4 LAN ports on the MBR1400.
Green = Connected to an active 10/100 Ethernet interface. Blinking Green = Traffic. Blue = Connected to an
active 10/100/1000 Ethernet interface. Blinking Blue = Traffic. No Light = Not connected, the connection is not
configured correctly, router is not configured correctly, or may not be turned on.
WPS WiFi Protected Setup. When you press the WPS button for five seconds, it allows you to use WPS for your
WiFi security. Blinking Blue = WPS setting is in progress. Solid Blue = WPS is active.
CradlePoint recommends using WPA2 WiFi Security.
WAN CONNECTION Indicates information about a data source connected to the WAN port (Blue Ethernet port).
Green = Connected to an active 10/100 Ethernet interface. Blinking Green = Traffic. Blue = Connected to an
active 10/100/1000 Ethernet interface. Blinking Blue = Traffic. No Light = Not connected, the connection is not
configured correctly, and/or router are not configured correctly or turned on.