Cradlepoint MBR1400 Series Setup Manual page 12

First Time Setup Wizard
6) If you are using a 4G WiMAX modem, you will want to establish the Realm for your carrier. This setting ensures
that the modem, when attached to the router, will properly connect to your carrier's wireless broadband service.
The MBR1400 will default to the Sprint 4G Realm. Select your carrier from the dropdown menu. Click NEXT.
7) If you are using a SIM-based modem (LTE/GSM/HSPA) with your CradlePoint router, you may need to configure
the Access Point Name (APN) before it will properly connect to your carrier. Wireless carriers offer several APNs,
so check with your carrier to confirm the appropriate one to use. Once you have chosen the APN setting, click
NEXT.
8) Set the Failure Check mode if desired. You may change the Idle Check Interval (Default: 30 seconds). By
default, the router will not check the WAN connection once a link has been established. Change the Monitor
while connected setting from Off to Active Ping to ensure active monitoring. To use Active Ping you will
need to input a Ping IP Address. Click NEXT.
9) Review the details and record your wireless network name, administrative password, and wireless WPA password.
Click APPLY to save the settings and update them to your router.
NOTE: If you are currently using the MBR1400 WiFi network, reconnect your devices to the network using the new
wireless network name and security password.
10